Adjust display settings.
Choose how long images are displayed after shooting. Colors may differ slightly from those in the final image and “noise” mottling may be visible at high sensitivities. Note that at some settings, the camera will display pictures after shooting regardless of the option selected.
Pictures are displayed until the [MENU/OK] button is pressed or the shutter button is pressed halfway. To zoom in on the active focus point, press the center of the sub-command dial; press again to cancel zoom.
Select [ON] to enable exposure preview in manual exposure mode. Select [OFF] when using a flash or on other occasions on which exposure may change when the picture is taken.
Adjust monitor brightness.
Adjust monitor hue.
Choose [ON] to preview the effects of film simulation, white balance, and other settings in the monitor. Choose [OFF] to make shadows in low-contrast, back-lit scenes and other hard-to-see subjects more visible.
If [OFF] is selected, the effects of camera settings will not be visible in the monitor and colors and tone will differ from those in the final picture. The display will however be adjusted to show the effects of advanced filters and of monochrome and sepia settings.
Choose the type of framing grid available in shooting mode.
For “rule of thirds” composition.
A six-by-four grid.
Frame HD pictures in the crop shown by the lines at the top and bottom of the display.
Choose [ON] to automatically rotate “tall” (portrait-orientation) pictures during playback.
If [ON] is selected, the camera will automatically zoom in on the view through the lens when the focus ring is rotated in manual focus mode.
Choose the units used for the focus distance indicator.
Choose items for the standard display.