The camera can be used with lenses for the FUJIFILM G-mount.
- Lens Parts
- Lens Care
- Removing Lens Caps
- Attaching Lens Hoods
- Aperture ring
- Lenses with No Aperture Rings
DAperture ring lock release
EMounting marks (focal length)
GLens signal contacts
HFront lens cap
IRear lens cap
A GF63mmF2.8 R WR lens is used here for illustrative purposes.
Use a blower to remove dust, then gently wipe with a soft, dry cloth. Any remaining stains can be removed by wiping gently with a piece of FUJIFILM lens-cleaning paper to which a small amount of lens-cleaning fluid has been applied. Replace the front and rear caps when the lens is not in use.
Removing Lens Caps
Remove lens caps as shown.
Lens caps may differ from those shown.
Attaching Lens Hoods
When attached, lens hoods reduce glare and protect the front lens element.
Rotate the lens aperture ring to choose the aperture (f-number).
|C||Set aperture to the value chosen with the camera command dial.|
|A||Set aperture to the value chosen automatically by the camera.|
|Other values||Set aperture to the selected value.|
To select C or A, or to select another value after selecting C or A, press the aperture ring lock release while rotating the aperture ring.
Lenses with No Aperture Rings
The method used to adjust aperture can be selected using DBUTTON/DIAL SETTING > APERTURE SETTING. When an option other than AUTO is selected, aperture can be adjusted using the front command dial.
Aperture control defaults to the front command dial, but can be reassigned to the rear command dial using DBUTTON/DIAL SETTING > COMMAND DIAL SETTING.