Attaching the Strap
Attach the strap clips to the camera and then attach the strap. Proceed directly to Step 6 if the camera came with the clips and protective covers already attached.
Attach a protective cover.
Place a protective cover over the eyelet as shown, with the black side of the cover toward the camera.
Open a strap clip.
Use the clip attaching tool (A) to open a strap clip (B).
Slide the clip onto the tool.
Slide the clip onto the tool so that it hooks over the projection.
Place the strap clip on an eyelet.
Hook the strap eyelet in the clip opening. Remove the tool, using the other hand to keep the clip in place.
Keep the tool in a safe place, as you will need it to open the strap clips when removing the strap.
Pass the clip through the eyelet.
Rotate the clip fully through the eyelet until it clicks closed.
Fasten the strap.
Insert the strap through a protective cover and strap clip and fasten the buckle as shown.
To avoid dropping the camera, be sure the strap is correctly secured.
Strap clip Buckle
Repeat the above steps for the second eyelet.