This website uses cookies. By using the site you are agreeing to our Privacy Policy.

Enter a search term and click .

Use the built-in flash for additional lighting when shooting at night or indoors under low light.

The flash modes available vary with the shooting mode.

Press the function button to display the following options, then use the selector to highlight an option and press MENU/OK to select.

The flash fires when required. Recommended in most situations.
The flash fires whenever a picture is taken. Use for backlit subjects or for natural coloration when shooting in bright light.
Capture both the main subject and the background under low light (note that brightly lit scenes may be overexposed).
The built-in flash can be used to control optional remote flash units.
Select when using optional third-party flash units.
The flash does not fire even when the subject is poorly lit. A tripod is recommended.

If is displayed when the shutter button is pressed halfway, the flash will fire when the photo is taken.

Except in commander mode, the flash may fire several times with each shot. Do not move the camera until shooting is complete.

Remove lens hoods to prevent shadows in photos taken with the flash.

Flash options can also be accessed using the FLASH SET-UP option in the shooting menu.

Red-Eye Removal

When “intelligent face detection” is active, and on is selected for “red eye removal”, red-eye removal is available in , , . Red-eye removal minimizes “red-eye” caused when light from the flash is reflected from the subject’s retinas.

Flash Sync Speed

The flash will synchronize with the shutter at shutter speeds of 1/2000 s or slower.

Optional Flash Units

The camera can also be used with optional FUJIFILM shoe-mounted flash units. Do not use third-party flash units that apply over 300 V to the camera hot shoe.