After charging the battery, insert the battery in the camera as described below.
Open the battery-chamber cover.
Slide the battery-chamber latch as shown and open the battery-chamber cover.
Do not open the battery-chamber cover when the camera is on. Failure to observe this precaution could damage image files or memory cards.
Do not use excessive force when handling the battery-chamber cover.
Insert the battery.
Using the battery to keep the battery latch pressed to one side, insert the battery contacts first in the direction shown by the arrow. Confirm that the battery is securely latched.
Insert the battery in the orientation shown. Do not use force or attempt to insert the battery upside down or backwards. The battery will slide in easily in the correct orientation.
Insert the memory card
Holding the memory card in the orientation shown, slide it in until it clicks into place at the back of the slot.
Be sure card is in the correct orientation; do not insert at an angle or use force.
Close the battery-chamber cover.
Removing the Battery
Before removing the battery, turn the camera off and open the battery-chamber cover.
To remove the battery, press the battery latch to the side, and slide the battery out of the camera as shown.
The battery may become hot when used in high-temperature environments. Observe caution when removing the battery.
Removing Memory Cards
Before removing memory cards, turn the camera off and open the battery-chamber cover.
Press and release the card to eject it part way (to prevent the card falling from the slot, press the center of the card and re-lease it slowly, without removing your finger from the card). The card can then be removed by hand.