This website uses cookies. By using the site you are agreeing to our Privacy Policy.

Enter a search term and click .

Dust that cannot be removed using the VSENSOR CLEANING option in the setup menu can be removed manually as described below.

Note that there will be a charge to repair or replace the image sensor if it is damaged during cleaning.

  1. Use a blower (not a brush) to remove dust from the sensor.

    Do not use a brush or blower brush. Failure to observe this precaution could damage the sensor.

  2. Check whether the dust has been successfully removed. Repeat Steps 1 and 2 as necessary.

  3. Replace the body cap or lens.