Adjust display settings.
Adjust the brightness of the display in the electronic viewfinder, or choose AUTO for automatic brightness adjustment.
Adjust the hue of the display in the electronic viewfinder.
Adjust monitor brightness.
Adjust monitor hue.
Choose how long images are displayed after shooting. Colors may differ slightly from those in the final image and “noise” mottling may be visible at high sensitivities.
Pictures are displayed until the MENU/OK button is pressed or the shutter button is pressed halfway. To zoom in on the active focus point, press the center of the rear command dial; press again to cancel zoom.
Choose whether the indicators in the viewfinder rotate to match camera orientation. Regardless of the option selected, the indicators in the monitor do not rotate.
Select PREVIEW EXP./WB to enable exposure and white balance preview in manual exposure mode, or choose PREVIEW WB to preview only white balance. Select OFF when using a flash or on other occasions on which exposure may change when the picture is taken.
Choose ON to preview the effects of film simulation, white balance, and other settings in the monitor. Choose OFF to make shadows in low-contrast, back-lit scenes and other hard-to-see subjects more visible.
If OFF is selected, the effects of camera settings will not be visible in the monitor and colors and tone will differ from those in the final picture. The display will however be adjusted to show the effects of advanced filters and of monochrome and sepia settings.
Choose the type of framing grid available in shooting mode.
For “rule of thirds” composition.
A six-by-four grid.
Frame HD pictures in the crop shown by the lines at the top and bottom of the display.
Choose ON to automatically rotate “tall” (portrait-orientation) pictures during playback.
Choose the units used for the focus distance indicator.
Choose items for the standard display. Highlight OVF or EVF/LCD and press MENU/OK. Highlight items and press MENU/OK or deselect.
.
